[C1004W] Booting Log

= [C1004W] Booting Log

[CFE]
CFE version 1.0.38-116.174 for BCM96838 (32bit,SP,BE)

Chip ID: BCM68380_B0, MIPS: 600MHz, DDR: 533MHz, Bus: 240MHz
RDP: 800MHz
Main Thread: TP0

Total Memory: 268435456 bytes (256MB)
Boot Address: 0xbfc00000

NAND flash device: Spansion S34ML01G1, id 0x01f1 block 128KB size 131072KB (128M)

Run from flash/host/tftp (f/h/c)  : f 
Default host run file name        : vmlinux 
Default host flash file name      : bcm963xx_fs_kernel 

Board Id (0-42)                   : C1004WAE 
Number of MAC Addresses (1-32)    : 6 
Base MAC Address                  : 00:24:45:03:92:de

Serial Number                     : W11M14430232 
Wireless Password Phrase          : qexa1232cava 
MC memory allocation (MB)         : 4 
TM memory allocation (MB)         : 20 

Open PHY 1 on MAC 0 : link state = Down
Open PHY 2 on MAC 1 : link state = Down
Open PHY 3 on MAC 2 : link state = Down
Open PHY 4 on MAC 3 : link state = Down

Booting from latest image (address 0xc3980000, flash offset 0x03d80000) ...
Decompression OK!
Starting program at 0x80347130

#------------------------------------------------------------------------------------
[OS]
Linux version 3.4.11-rt19 (firstpw@ubi-10) (gcc version 4.6.2 (Buildroot 2011.11) ) #1 SMP PREEMPT Thu Oct 29 11:06:40 KST 2015

CPU revision is: 0002a080 (Broadcom BMIPS4350)

Kernel command line: ro noinitrd  irqaffinity=0
Memory: 226512k/237568k available (3349k kernel code, 11056k reserved, 862k data, 200k init, 0k highmem)
NR_IRQS:256
console [ttyS0] enabled
--Kernel Config--
  SMP=1
  PREEMPT=1
  DEBUG_SPINLOCK=0
  DEBUG_MUTEXES=0
Broadcom Logger v0.1 Oct 29 2015 11:03:14
Brought up 2 CPUs
BLOG v3.0 Initialized
BLOG Rule v1.0 Initialized
Broadcom IQoS v0.1 Oct 29 2015 11:06:37 initialized
Broadcom GBPM v0.1 Oct 29 2015 11:06:37 initialized

NET: Registered protocol family 2 #define ADDR_FAMILY_IPV6 0x02
IP route cache hash table entries: 2048 (order: 1, 8192 bytes)
TCP established hash table entries: 8192 (order: 4, 65536 bytes)
TCP bind hash table entries: 8192 (order: 4, 65536 bytes)
TCP: Hash tables configured (established 8192 bind 8192)
TCP: reno registered
UDP hash table entries: 128 (order: 0, 4096 bytes)
UDP-Lite hash table entries: 128 (order: 0, 4096 bytes)
NET: Registered protocol family 1 #define ADDR_FAMILY_IPV4 0x01

bcm_tstamp initialized, (hpt_freq=300000000 2us_div=300 2ns_mult=0 2ns_shift=0)
jffs2: version 2.2. (NAND) © 2001-2006 Red Hat, Inc.
BrcmNAND mfg 1 f1 SPANSION_S30ML01GP_08 128MB on CS0

***** Found UBIFS Marker at 0x040dff00
***** Found UBIFS Marker at 0x0037ff00
Creating 8 MTD partitions on "brcmnand.0":
128MB : 0x8000000
#-----------------------------------------------------
0x000000000000-0x000000020000 : mtd3 CFE("nvram":for CFE Env)

#-----------------------------------------------------
0x000000020000-0x000000380000 : mtd7 "bootfs_update"
0x000000380000-0x000003d80000 : mtd1 "rootfs_update"
=
0x000000020000-0x000003d80000 : mtd5 "image_update"
#-----------------------------------------------------
0x000003d80000-0x0000040e0000 : mtd6 "bootfs"
0x0000040e0000-0x000007ae0000 : mtd0 "rootfs"
=
0x000003d80000-0x000007ae0000 : mtd4 "image"
#-----------------------------------------------------
0x000007b00000-0x000007f00000 : mtd2 "data"
#-----------------------------------------------------

Serial: BCM63XX driver $Revision: 3.00 $
ttyS0 at MMIO 0xb4e00500 (irq = 9) is a BCM63XX
ttyS1 at MMIO 0xb4e00520 (irq = 10) is a BCM63XX
BPM: tot_mem_size=268435456B (256MB), buf_mem_size <10%> =26843540B (25MB), num of buffers=10356, buf size=2592
u32 classifier

TCP: cubic registered
NET: Registered protocol family 10
IPv6 over IPv4 tunneling driver
NET: Registered protocol family 17
Ebtables v2.0 registered
8021q: 802.1Q VLAN Support v1.8

UBIFS: mounted UBI device 0, volume 0, name "rootfs_ubifs"
VFS: Mounted root (ubifs filesystem) readonly on device 0:10.

init started: BusyBox v1.17.2 (2015-10-29 11:08:45 KST)
   
gpon_stack: module license 'Proprietary' taints kernel.
nvram TM 20MB: bpm buffers to allocate: 7680

Bridge fastpath module. compiled Oct 29 2015 , 11:06:21
Broadcom Ingress QoS Module  Char Driver v0.1 Oct 29 2015 11:03:21 Registered<243>
Broadcom Packet Flow Cache  Char Driver v2.2 Oct 29 2015 11:03:21 Registered<242>
Created Proc FS /procfs/fcache
Broadcom BCM68380_B0 Ethernet Network Device v0.1 Oct 29 2015 11:06:21
dgasp: kerSysRegisterDyingGaspHandler: bcmsw registered
eth0: <Int sw port: 0> <Logical : 00> PHY_ID <0x01800001 : 0x01> MAC : 00:24:45:03:92:DE
eth1: <Int sw port: 1> <Logical : 01> PHY_ID <0x01800002 : 0x02> MAC : 00:24:45:03:92:DE
eth2: <Int sw port: 2> <Logical : 02> PHY_ID <0x01800003 : 0x03> MAC : 00:24:45:03:92:DE
eth3: <Int sw port: 3> <Logical : 03> PHY_ID <0x01800004 : 0x04> MAC : 00:24:45:03:92:DE
eth4: <Int sw port: 5> <Logical : 05> PHY_ID <0x85800042 : 0x02> MAC : 00:24:45:03:92:DE

wl: passivemode=1
wl0: creating kthread wl0-kthrd
wl:srom/otp not programmed, using main memory mapped srom info(wombo board)
wl: ID=pci/2/0/
wl: loading /etc/wlan/ubi4360_11ac.bin
wl: reading /etc/wlan/bcmcmn_nvramvars.bin, file size=32
wl: reading /etc/wlan/bcm4360_nvramvars.bin, file size=32
wl0: allocskbmode=1 currallocskbsz=1024
wl0: Broadcom BCM4360 802.11 Wireless Controller 7.14.89.14.cpe4.16L03.0-kdb
dgasp: kerSysRegisterDyingGaspHandler: wl0 registered

wl: passivemode=1
wl1: creating kthread wl1-kthrd
wl: napimode=0
wl:srom/otp not programmed, using main memory mapped srom info(wombo board)
wl: ID=pci/4/0/
wl: loading /etc/wlan/ubi4360_11n.bin
wl: reading /etc/wlan/bcmcmn_nvramvars.bin, file size=32
wl: reading /etc/wlan/bcm4360_nvramvars.bin, file size=32
wl1: allocskbmode=1 currallocskbsz=3500
wl1: Broadcom BCM4360 802.11 Wireless Controller 7.14.89.14.cpe4.16L03.0-kdb
dgasp: kerSysRegisterDyingGaspHandler: wl1 registered

[NTC gpon] gponModuleCreate: RdpaWanType is not GPON ( GBE ), Remove module
insmod: can't insert '/lib/modules/3.4.11-rt19/extra/bcmgpon.ko': Operation not permitted

Broadcom 802.1Q VLAN Interface, v0.1

Starting CMS smd...
===== Release Version C1004W_T109 (build timestamp 151029_1108) =====
Initializing CMS MDM in Pure181 mode
netdev path : eth0.0 -> eth0
netdev path : eth1.0 -> eth1
netdev path : eth2.0 -> eth2
netdev path : eth3.0 -> eth3
BCMVLAN : eth0 mode was set to RG
BCMVLAN : eth1 mode was set to RG
BCMVLAN : eth2 mode was set to RG
BCMVLAN : eth3 mode was set to RG

Netfilter messages via NETLINK v0.30.

device eth0.0 entered promiscuous mode ==> left(because port is down)
br0: port 1(eth0.0) entered forwarding state
~~~~~port 4(3.0)

#===> ERROR <===
[ERROR enet] bcmeapi_ioctl_ethsw_port_pause_capability,591: invalid lan port id 8
WARNING: can't open config file: /usr/local/ssl/openssl.cnf

omcid can only be started when GPON link is active.MACSTR [00:24:45:03:92:DE]
ip_tables: (C) 2000-2006 Netfilter Core Team
ip6_tables: (C) 2000-2006 Netfilter Core Team
nf_conntrack version 0.5.0 (3542 buckets, 16000 max)

#===> ERROR <===
wlmngr2: invalid option -- m
WLMNGR: unsupported option 63, ignored

wlevt is ready for new msg...

(ssk) EthernetWan eth4 link up
eth4.1 MAC address set to 00:24:45:03:92:E2
netdev path : eth4.1 -> eth4
BCMVLAN : eth4 mode was set to RG
Created new Tag Rule: dev=eth4, dir=1, tags=0, id=0
Created new Tag Rule: dev=eth4, dir=0, tags=1, id=0
Created new Tag Rule: dev=eth4, dir=0, tags=2, id=0
Created new Tag Rule: dev=eth4, dir=0, tags=0, id=0
device eth4 entered promiscuous mode
eth4.1: no IPv6 routers present

<Wl0 : 5G>
#===> ERROR <=== : why wl1.x NOT wl0.x
ifconfig: wl1.1: error fetching interface information: Device not found
ifconfig: wl1.2: error fetching interface information: Device not found
ifconfig: wl1.3: error fetching interface information: Device not found

Chanspec set to 0xe02a
WPS Device PIN = 21464065
Setting SSID: "HOME5-92CE"
Setting SSID: "HOME5_1-92CE"
Setting SSID: "HOME5_2-92CE"
Setting SSID: "HOME5_3-92CE"
device wl0 entered promiscuous mode ==> left(because to do ...)
br0: port 5(wl0) entered forwarding state ==> disabled(because to do ...)

    <Repeat>
#===> ERROR <=== : why wl1.x NOT wl0.x
ifconfig: wl1.1: error fetching interface information: Device not found
ifconfig: wl1.2: error fetching interface information: Device not found
ifconfig: wl1.3: error fetching interface information: Device not found

Setting SSID: "HOME5-92CE"
Setting SSID: "HOME5_1-92CE"
Setting SSID: "HOME5_2-92CE"
Setting SSID: "HOME5_3-92CE"
device wl0 entered promiscuous mode
br0: port 5(wl0) entered forwarding state

<Wl1 : 2.4G>
Setting SSID: "HOME2.4-92CE"
Setting SSID: "HOME2.4_1-92CE"
Setting SSID: "HOME2.4_2-92CE"
Setting SSID: "HOME2.4_3-92CE"

#===> ERROR <===
wlmngr:error:49.660:oal_getPidByName:576:could not open /proc/3180/stat
wlmngr:error:49.660:oal_getPidByName:576:could not open /proc/3181/stat

device wl1 entered promiscuous mode
br0: port 6(wl1) entered forwarding state

wlctl: Not down

Setting SSID: "HOME2.4-92CE"
Setting SSID: "HOME2.4_1-92CE"
Setting SSID: "HOME2.4_2-92CE"
Setting SSID: "HOME2.4_3-92CE"